HobbyWorld presents a new line of self-adhesive, vinyl bases for models

Read the Full News Story

If you have comments or questions please post them here.

Thanks!

Clever idea
But ... 200 mm is barely adequate for many 1/35 models.
I measured the diagonal of the Merkava Mk 3D (early) by Meng and the result was about 230 mm. The area where the track touches the "ground" will probably fit inside a 200 mm circle and the rest will overhang the base (the barrel will obviously stick out a lot). An M109 (witout barrel of course) will fit, the A6 version will overhang a little due to the boxes at the rear of the turret. Translated to 1:1 the 1/35 patches represent a 7 metre (or almost 23 feet) circle which can hold a 2.5x6.5 or 3x6.3 metre (8.2x21 or 9.8x20.7 feet) rectangle.
I would humbly suggest oblong patches or offering them in smaller and larger sizes for 1:35.
The 200 mm is slightly large for the smaller stuff (like a Pz IV or Sherman) and gets crowded with Tiger II and most modern tanks. Then there is the minor detail of getting something in the right size to glue these on / Robin

Nicely put, I agree with what RN said