_GOTOBOTTOM
Armor/AFV: Large Scale
1/16 and Larger Armor Modeling
Hosted by Darren Baker
Wheels for 1/24 Willys Jeep
minoradmin
Visit this Community
Barcelona, Spain / Espaņa
Joined: January 12, 2011
KitMaker: 83 posts
Armorama: 81 posts
Posted: Sunday, June 11, 2017 - 03:57 AM UTC
Hello,:-H

I'm working on resin wheels for 1/24 Jeep.
Has separate break drums.
I agree your comments.


youngtiger1
Visit this Community
California, United States
Joined: May 14, 2008
KitMaker: 534 posts
Armorama: 344 posts
Posted: Tuesday, August 15, 2017 - 04:15 AM UTC
Nice wheels. How much they run?
m4sherman
Visit this Community
Arizona, United States
Joined: January 18, 2006
KitMaker: 1,866 posts
Armorama: 1,808 posts
Posted: Tuesday, August 15, 2017 - 04:55 AM UTC
Your wheels look good. I can't tell from the pictures, maybe it's an optical illusion. On the rear hubs the plate for the axle shaft is round. It does not have the notches like the front hubs.

On the rear axle shaft plates there are 8 holes. 6 evenly spaces for the bolts that secure the axle shaft to the hub, and 2 threaded holes that usually have a spare bolt secured with a nut. I'm told these were used to pull the axle shafts from the axle.

The cap on the tube was to keep it from getting pulled into the wheel if the tube lost air.



PITERPANZER
Visit this Community
Gdańsk, Poland
Joined: September 11, 2005
KitMaker: 319 posts
Armorama: 316 posts
Posted: Tuesday, August 15, 2017 - 10:02 PM UTC
When will be available?
 _GOTOTOP